Chris Hornbeck wrote:

On Wed, 31 Aug 2005 03:08:56 GMT, mike m
wrote:

snipped for bandwidth

Just for ****s-n-grins, swap both amps physically,
leaving everything else the same. This will
elimanate loads, wiring, etc. The Sherlock
Holmes ("After you've eliminated the...")
approach.

Then measure the DC resistance of your output
transformers and other esoteric-but-possible
failure modes. These guys are getting up
there in years.

Good fortune, and good hunting,

Chris Hornbeck
Hi Chris
Did the old swap amp-leave all else same.
do you have Dc values for out put tranny?
Thanks
Mike M